16 en | Preparing for an E2700 controller-drive tray installation DSA E-Series (E2700)
2015.10 | V2 | DOC Installation manual Bosch Sicherheitssysteme GmbH
1 Active SFP transceiver
2 Copper cable with RJ-45 connector
SAS cable connection with SFF-8644 connector
1 SAS cable
2 SFF-8644 connector
4.4 Things to know –taking a quick glance at the hardware in a
E2700 controller-drive tray configuration
The E2700 systems always come with eight or twelve hard drives. At least two drives are
required for proper operation.
This section provides an overview of hardware described in this document.
Observe the following:
– The top of the controller-drive tray is the side with labels.
– The configuration of the host ports might appear different on your system depending on
which host interface card configuration is installed.
E2700 controller-drive tray – front view
1 End cap Locate LED
2 End cap Service action required LED
3 End cap over-temperature LED
4 End cap Power LED
5 End cap Standby power LED
6 Drive canister
To Next Page
Loading...