Bosch FLEXIDOME multi 7000i Installation Manual

8 en | System overview FLEXIDOME multi 7000i
2021-03 | 01 |
Installation manual
Bosch Security Systems B.V.
3 System overview
3.1 Product description
The FLEXIDOME multi 7000i camera is built for high-quality performance, featuring four
independent imagers with motorized zoom/focus lenses. It helps to simplify installation and
lower costs while maintaining flexibility in coverage. With four scenes simultaneously in a
single camera, it is perfect for wide area coverage, traffic intersections and building corners.
When the lenses are tilted at the right angle, the camera can even cover an area up to full
360°. Additionally, the zoom capability allows the camera to obtain detailed coverage for more
distant areas.
Product overview
1
5
7
2
3
6
4
1 Mounting plate 2 Reset button
3 LED 4 USB-C port
5 8-pin Audio and I/O connector 6 Microphone
7 Camera dome cover
LED overview
LED behavior Description
Red LED lights up Startup is in progress.
Red LED flashes The unit is faulty, for example following failed
firmware upload.
Refer to Resolving problems, page 32 .
Green LED lights up The unit is switched on and startup is
completed.

Bosch FLEXIDOME multi 7000i Specifications

General

Camera Type	Dome
Sensor Type	CMOS
Day/Night Functionality	Yes
Video Compression	H.265, H.264, MJPEG
Ingress Protection	IP66
Impact Protection	IK10
Sensors	1/1.8-inch CMOS
Focal Length	2.8 - 10 mm
Minimum Illumination	B/W: 0.01 lux (typical values, varies by model)
Infrared	No
WDR	Yes (120 dB)
Frame Rate	Up to 30 fps
Audio	Two-way audio
Analytics	Intelligent Video Analytics
Power	PoE (Power over Ethernet) or 24 VAC