Bosch FLEXIDOME multi 7000i - Audio Settings

FLEXIDOME multi 7000i | FLEXIDOME multi 7000i
IR
Configuration | en 31
Bosch Security Systems B.V.
User manual
2021-04 | 01 |
Custom color.
The Privacy Masks can be selected for each of the four video channels. Each video channel
corresponds to one of the four imagers in the camera. Up to 8 masks can be set for each
imager individually.
A total of eight (8) masks can be in view at the same time.
To configure a Privacy mask:
– Select the mask number from the drop-down list.
– Click the plus button.
– Adjust the mask in the image:
– Double-click on the edges to add or remove nodes.
– Click and drag the nodes to position them correctly.
– Check the Enabled check box to activate the related mask.
– Click the Set button to apply the related changes.
To delete a Privacy mask:
– Select the mask number from the drop-down list.
– Click the trashcan icon.
– Click the Set button to apply the changes.
4.4.13 Audio
You can set the gain of the audio signals to suit your specific requirements. The live video
image is shown in the window to help you check the audio source. Your changes are effective
immediately.
If you connect via Web browser, you must activate the audio transmission on the 'Live'
functions page. For other connections, the transmission depends on the audio settings of the
respective system.
The audio signals are sent in a separate data stream parallel to the video data, and so increase
the network load. The audio data is encoded according to the selected format and requires
additional bandwidth. If you do not want any audio data to be transmitted, select Off.
Audio
Enable or disable the audio recording option.
Audio input
Select which audio input you want to use. Available options are Line In or integrated
Microphone.
Microphone volume
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
Line Out
Adjust the audio level with the slider(s). Adjust so that the indicator does not go into the red
zone.
Recording format
Select a format for audio recording. The default value is AAC 48 kbps. You can select AAC 80
kbps, G.711 or L16 depending on the required audio quality or sampling rate.
AAC audio technology is licensed by Fraunhofer IIS.
(http://www.iis.fraunhofer.de/amm/)
Send audio
Audio can be sent via the Send audio button if the unit supports audio. The button activates
the audio backchannel connection.
1. Click and hold the Send audio button to send an audio signal to the unit.
2. Release the button to stop sending audio.