Bosch FLEXIDOME multi 7000i User Manual (English)

Other manuals for Bosch FLEXIDOME multi 7000i

Questions and Answers:

T
Thomas CooperJul 28, 2025
What to do if my Bosch IP Camera has no connection and no image transmission?
- D
  Dr. Erin YoungJul 28, 2025
  If your Bosch IP Camera isn't establishing a connection or transmitting images, there are several potential causes. First, verify all configuration parameters, and if needed, reset to factory defaults. Then, check all cables, plugs, contacts, and connections to ensure proper installation. Confirm that the IP address is correct by using the ping command. Also, check data transmission within the LAN using ping. Finally, if the maximum number of connections has been reached, wait until a connection becomes available before attempting to transmit again.
C
Christopher MoralesAug 4, 2025
Why my Bosch IP Camera does not operate?
- R
  Robert FordAug 4, 2025
  If your Bosch IP Camera unit does not operate, the possible cause is a power failure. Check the power supply to ensure it is functioning correctly. Also, verify whether PoE+ or a 24 V auxiliary input is being used. Another possible cause is faulty cable connections. Check all cables, plugs, contacts, and connections to ensure they are properly connected.
T
thomas86Aug 13, 2025
What to do if Bosch IP Camera is not operational after firmware upload?
- S
  smithpatriciaAug 13, 2025
  If your Bosch IP Camera is not operational after a firmware upload, it could be due to a power failure during the programming process. In this case, have the unit checked by Customer Service and replaced if necessary. Another possible cause is using an incorrect firmware file. To resolve this, enter the IP address of the unit followed by /main.htm in your web browser and repeat the upload, ensuring that you only use CPP14 firmware files.
G
guerrabrianAug 20, 2025
How to fix empty fields in web browser for Bosch IP Camera?

Bosch FLEXIDOME multi 7000i Specifications

General

Camera Type	Dome
Sensor Type	CMOS
Day/Night Functionality	Yes
Video Compression	H.265, H.264, MJPEG
Ingress Protection	IP66
Impact Protection	IK10
Sensors	1/1.8-inch CMOS
Focal Length	2.8 - 10 mm
Minimum Illumination	B/W: 0.01 lux (typical values, varies by model)
Infrared	No
WDR	Yes (120 dB)
Frame Rate	Up to 30 fps
Audio	Two-way audio
Analytics	Intelligent Video Analytics
Power	PoE (Power over Ethernet) or 24 VAC