24 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts VG4 Modular Camera Series
F.01U.216.010 | 8.0 | 2011.02 Installation Manual Bosch Security Systems, Inc.
8. Attach the supplied 3-pin power plug to the incoming 24 VAC power wires in the box, as
illustrated below.
Figure 2.8 VG4-PA0 Power Supply Box
9. Follow the instructions in Section 2.6 Attach Pendant Arm to Power Supply Box, page 25, to
continue the installation.
1 Incoming 24 VAC Power Supply Wires (from VG4-PSU1/VG4-PSU2 power supply box)
2 Ground Wire
3 P101 Connector
4 Control Data and Video In/Out Wires
GND
+
-
ND
X
+
-
P1
P1
P107
XF102 XF103
XF101
5 4 3 2 1
1
2
101
FUSE
FUSE
FUSE)