Bosch Intellic EFAS-4.10 - EFAS Tachograph Technical Data; Technical Data Specifications for EFAS

58
Workshop Manual
Smart Tachograph EFAS-4.10/4.11
SrvID
hex
EFT
hex
DTC Symbol
Display text
Description and trouble-shooting
S13 06 40 00 000200
! Last use of card
not nished
Meaning / Cause:
A tachograph smart-card has been inserted into card slot 1 after
the card was previously inserted in another tachograph and was
not closed down properly.
The following causes are possible:
y Improper or forced removal of the card (tampering attempt).
y A write error has occurred when it was used in the previous
device.
Measures:
y The card is closed automatically by EFAS after inserting
it in one of the two card slots. The error should not recur
thereafter.
y If possible, check the card reader of the previous device.
y Watch for other card errors (also see service IDs S7/S8 and
service IDs S39/S40).
S14 06 40 00 000300
! Last use of card
not nished
This error matches the previous one, however, for card slot 2.
S15
14
14 40 00 000200
!  Security
violation
Meaning / Cause:
The integrity (authenticity) of the data on the tachograph smart-
card in the card slot 1 is not assured. Errors have been detected
in the data structure by the security module of EFAS.
The following causes are possible:
y A defective card locking mechanism of EFAS (a defect in the
card reader is unlikely with such a fault, since in this case,
other error codes are reported).
y A defective tachograph card.
y An attempt at tampering.
Measures:
y Check the tachograph smart-card in the other card slot or in
another device.
y Check the card locking mechanism of the recording equip-
ment (please take note of the remarks given under service
ID 17 and ID 18!).
y Replace the tachograph smart-card.
S16
14
14 40 00 000300
!  Security
violation
This error matches the previous one, however, for card slot 2.
S17 18 40 00 000400
!  Security
violation
Meaning / Cause:
A tachograph card was manually removed from card slot 1
without pressing the eject key or EFAS has determined, after
supply voltage interruption, that the card is no longer in the slot.
Measures:
Insert a card in the slot the wrong way round *) for testing
purpose and check whether the card locking mechanism of the
tachograph is defective. It should not be possible to remove the
card manually.
y A tachograph having a defective locking mechanism must
be replaced.
y Caution: The card should be inserted the wrong way round
(contact surfaces facing downwards) since, in the event of
a defective locking mechanism, the card may be provided
with defective information on account of incomplete write
operations!
S18 18 40 00 000500
!  Security
violation
This error matches the previous one, however, for card slot 2.
14 The EFT for this event or the malfunction is not stored to the mass memory in the CALIBRATION operating mode. Information appears in the display with the specication of the
SrvID that this event or malfunction has been detected for a short duration.