The table below identifies the power devices that can be connected simultaneously to the
camera.
If power is supplied from: Camera can receive power simultaneously from:
60 W midspan (NPD-6001A)
24 VAC PSU
(VG4-A-PSU1,
VG4-A-PSU2)
95 W midspan (NPD-9501A)
VIDEOJET connect (NPD-PSU-HPOE)
Caution!
Compliance with EN50130-4 Alarm Standard – CCTV for Security Applications
To meet the requirements of the EN50130-4 Alarm Standard, an ancillary uninterruptable
power (UPS) supply is necessary. The UPS must have a Transfer Time between 2–6 ms and a
Backup Runtime of greater than 5 seconds for the power level as specified on the product
datasheet.
Ethernet Connections
Caution!
Ethernet cables must be routed through earth-grounded conduit capable of withstanding the
outdoor environment.
Note: Consult the National Electrical Code (NEC) for cable bundling requirements and
limitations.
Cable Type Cat5e/Cat6 Ethernet (directly to the camera, or to a network switch
between the camera and the network)
Maximum Distance 100 m (330 ft)
Bandwidth 100 Base-TX
High PoE (required for models with
illuminators)
Use the 95 W midspan sold by Bosch.
PoE+ (only for models without
illuminators)
Use the 60 W midspan sold by Bosch, or a midspan that is compliant to the
IEEE 802.3at, class 4 standard.
Terminal Connector RJ45, Male
10.3
26 en | Make Connections - Power and Control
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
2014.05 | 1.0 | F.01U.291.520 Operation Manual Bosch Security Systems, Inc.
To Next Page
Loading...
