Notice!
If your MIC camera will be canted, install the sunshield first.
If your MIC camera will have both illuminator and sunshield accessories, install the illuminator
first.
Extreme low temperature models do not support a sunshield.
To cant the camera, follow these steps:
1. Remove the yoke cap (item 3 in the figure below) on one yoke arm of the camera, using a
Torque wrench with ¼ in. drive (item 1, not supplied) with the spanner tool (item 2,
supplied).
Repeat for the second arm.
Figure 11.2: Remove yoke caps with spanner tool
2. Remove the two (2) T27 Torx screws at the bottom of one yoke arm using a T27 Torx
wrench (not supplied).
30 en | Cant the Camera
MIC IP starlight 7000 HD, MIC IP
dynamic 7000 HD
2014.05 | 1.0 | F.01U.291.520 Operation Manual Bosch Security Systems, Inc.
To Next Page
Loading...
