Installation
Preparation
To separate the different parts of the camera:
1. Remove the outer dome by unscrewing the 3 attachment
bolts.
2. Remove the inner dome by gently pulling it from its mount
seal.
3. Store the domes in a safe place where the outer dome
cannot become scratched.
4. Remove the camera module from the surface mount box by
unscrewing the 3 screws.
To remove the desiccant sachet:
1. Slide the sachet out of its storage slot in the camera.
2. Dispose of the sachet in an environmentally friendly way.
To Next Page
Loading...
