Power amplifier Installation | en 23
Bosch Security Systems B.V.
Installation manual
2023-01 | V02 | F.01U.402.247
5.2.2 AMP-LINK
AMP‑LINK functions as either an input of 4 channels via a single cable connection, or as audio
output when the Euroblock inputs are in use. This allows one set of inputs from the Euroblock
connections to go to another amplifier. AMP‑LINK is compatible with any AES72‑1E device.
– AMP‑LINK is a port with 4 balanced analog audio lines, which makes cabling with
compatible devices easy.
– AMP-LINK is compatible with standard CAT5e or CAT6 wiring and it is recommended to
use a quality shielded STP cable for increased distances over 5m to 25m to reduce audio
and signal degradation by maintaining balanced signal.
The wiring of AMP‑LINK is below.
Notice!
The wiring is according to AES72‑1E.
Caution!
Do not connect AMP‑LINK with Ethernet, CAN bus, Call station, or even PoE powered ports!
Noise can occur which may damage speakers or the amplifier.
Refer to
– Indicators, controls and settings, page 16
To Next Page
Loading...
