-16-
Unpacking and Checking Contents
Unpacking the Miter Saw
To avoid severe pinching, never lift
or move this saw by gripping any
component of the mechanism support system.
When removing this tool from packaging materials, reach
down to the two side carry-handle locations and slowly lift
until it clears the package.
Checking Contents in Package
Open the top of the package and look for the included loose
parts (Fig. 4).
Some small parts must be attached to the tool before it is
ready for use.
Fig. 4
Loose Parts
2 Workpiece Clamps (42)
Torx Wrench (41)
2 Base Extensions (16)
4 Torx Screws for Base Extensions
Dust Bag (36)
Miter Lock Knob (20)
Operating/Safety
Instructions
Check off each part.
To Next Page
Loading...
