-41-
Saw Operations
3. Adjust your left or right bevel stop indicator (33) to one
of the three pre-set locations, 33.9°, 45°, 47°, or tilt the
head assembly (Fig. 47, 28) until you reach the desired
angle on your bevel scale (Fig. 49 and Fig. 50, 10).
NOTE: To bevel the saw to the right, the Bevel Range Se-
lector Knob must be pulled forward (Fig. 50, 11).
4. Lock the bevel by rotating the bevel lock knob (34) coun-
terclockwise.
5. Follow either the procedure “Chop Cuts” on page 37
or “Slide Cuts” on page 38.
Bevel scale information
“30” position for
cutting 45° “spring
angle” crown molding flat
on table
“33.9” positions are for cutting 38° “spring
angle” crown molding flat on table
NOTE: Saw has a 33.9 detent feature to
automatically hold it at this bevel angle
setting
Watch while tilting to right Watch while tilting to left
Fig. 49
33
34
10
11
Fig. 50
To Next Page
Loading...
