Bosch PROFACTOR GCM18V-10SDN14 - Miter and Bevel Settings for Standard Crown Molding Cuts (With Molding Flat on Table)

-47-
Saw Operations
Miter and Bevel Settings for Standard Crown Molding Cuts
(With Molding Flat on Table)
Assumptions: Molding is milled consistently. Corner is exactly 90°.
Molding
Spring Angle 38°
Molding
Spring Angle 45°
NOTE: Always place top edge
against fence
Miter (Table)
Setting
Bevel (Tilt)
Setting
Miter (Table)
Setting
Bevel (Tilt)
Setting
Inside Corner
Left end (Fig. 55, A)
Use the left end of the cut
31.6° Right 33.9° Left 35.3° Right 30° Left
Right end (Fig. 55, B)
Use the right end of the cut
31.6° Left 33.9° Right 35.3° Left 30° Right
Outside Corner
Left end (Fig. 55, C)
Use the left end of the cut
31.6° Left 33.9° Right 35.3° Left 30° Right
Right end (Fig. 55, D)
Use the right end of the cut
31.6° Right 33.9° Left 35.3° Right 30° Left
52° 45°
38°
45°
Inside
corner
Outside
corner
Fence
Top of
molding
against
fence
Table
Ceiling
38° spring angle
45° spring angle
Ceiling
Wall
Wall
45/45° crown
molding
38/52° crown
molding
Fig. 55