-49-
Saw Operations
OVERALL HEIGHT = 1” (26mm)
6-1/2” (292mm)
2-1/4
(57mm)
2-1/4
(57mm)
6-1/2” (292mm)
OVERALL LENGTH = 22-1/2” (572mm)
1/2” (13mm)
Drill 4 holes = 5/16” (8mm) diameter
Nut (need 4)
Flat washer (need 4)
1/2” (13mm) countersink
5/16” (8mm) hole through
New auxiliary fence
Board: 3/4” Wide x 1-1/2” High
(19x38mm)
New auxiliary fence (assembled
to miter saw)
Stationary
fence
Stationary
fence
Top of base
and table
Top of base
and table
NOTE: The stationary fence
is permanently attached
to the saw base (do not
remove).
Saw base
Saw base
1/4” (M6) flat head machine screw x
2-1/2” (65mm) long (need 4)
Fig. 58
To Next Page
Loading...
