Bosch Radion B810 - UL product requirements

3. Select the Signal menu option and choose the desired repeater. Various sub-categories
display including:
– Signal Strength
– Level
– Margin
4. When finished, exit the menu.
Enroll point RF ID for wireless points (Auto-learn mode)
A second option exists whereby new devices are discovered on the system. This option is
referred to as the “Auto Learn Mode” option. Auto Learn Mode is the process through which
the control panel identifies and enrolls new device RF ID’s that appear within the system. This
is achieved by the following:
– Keyfobs – when the keyfob buttons are pressed, then released.
– Motion detectors – when the battery is inserted, or if coverage pattern is disturbed by
someone walking through the coverage pattern field.
Notice!
The Auto Learn mode option is not recommended as the preferred method of entering in the
RF ID’s due to the potential of the RADION system picking up the first available RF ID it
detects. For optimal results, manually enter in the RF ID’s through the supported keypad, or
via RPS.
Enrolling a wireless point RF ID
Using a supported keypad, enroll the RF ID through the Wireless menu option. Use the
Wireless menu to add, replace, remove, and diagnose points and repeaters.
Perform the following to enroll in the RF ID:
1. From the keypad, access the Wireless Menu, and select the Points menu option. If
adding a repeater, select the Repeater menu option.
2. Select the option for enrolling a point RFID.
3. When asked, select the point source you are enrolling).
4. Initiate activity for the desired device (walk through the coverage pattern if enrolling a
motion detector, or press the button on the keyfob if enrolling a keyfob, open the door or
window if enrolling a contact). By doing so, the control panel recognizes the first RFID it
comes in contact with.
5. When the keypad or RPS shows Point Enrolled, exit out of the application.
6. Verify the RFID displayed on the keypad matches the RFID sticker that appears on the
activated device.
Walk test (for motion detectors)
Use the following pattern testing procedure to test the detector range and functionality.
Notice!
Also see Control Panels (D9412GV4/D7412GV4 v2.00) SIA CP-01 Quick Reference Guide P/N: F.
01U.265.466, and/or Control Panels (B5512/B4512) SIA CP-01 Quick Reference Guide P/N: F.
01U.265.464.
3.3.5
3.3.6
18 en | RADION receiver SD RADION receiver SD
2014.03 | 06 | F.01U.261.834 Reference Guide Bosch Security Systems, Inc.