Specifications
Dimensions 139.70 mm x 209.60 mm x 31.80 mm
(5.50 in x 8.25 in x 1.25 in)
Compatible plug-in transformers
RFRP-A:
– BOSCH CX4010 Plug-in Transformer – F.01U.020.504 (110 VAC primary voltage input, 18 VAC, 22
VA)
– BOSCH D1640 Plug-in Transformer – 4.998.125.832 (16 VAC, 40 VA
– MG Electronic (MGT-1640), primary rated 120 VAC, 60 Hz, 0.48 Amps, secondary rated 16.5 VAC,
40 VA
– Codex (SEP-1640), primary rated 120 VAC, 60 Hz, 0.48 Amps, secondary rated 16.5 VAC, 40 VA
– TDC Part No (DA-22-18), primary rated 120 VAC, 60 Hz, 30 Va, secondary rated 18 VAC, 1.3 Amps,
22 VA
Power/Voltage
(Standby battery) RFRP-A
16.5 VAC, 40VA (~)
Rated 3.7 VDC, 3050mAH EVE ENERGY CO Part No P0046-LF (Not user
replaceable). For standby battery to be operative, the tamper switch is
required to be engaged.
Transformer power/voltage 120VAC, 60 Hz, 30 Va, or 120VAC, 60 Hz, 0.48 Amps
Current Draw 60 mA
Wire Gauge 0.65 mm (22 AWG) to 2.0 mm (18 AWG)
Temperature (operating) 0ﾟC to +49ﾟC (+32ﾟF to+120ﾟF)
Relative Humidity 0% to 93% (non-condensing)
Device testing To ensure proper functionality, the device must be tested at least once
every year by an installer.
Wall and Cover Tamper Switch Transmits a tamper signal when someone removes the device from its
base or pulls it away from the wall.
Frequency 433.42 MHz
Table 4.1: Specifications
LEDs
The repeater utilizes an external LED indicator to status the operation of the repeater. Refer to
the table below for LED descriptions.
LED Condition Pattern Description
On (Normal) – Indicates the repeater is functioning normally.
Off – Indicates there is a power failure to the repeater, or that the
receiver is not wired correctly.
Continuous Flash: 1 sec
rate for 5 sec
– Indicates the repeater is being powered up, and conduction
manufacturing test initializations.
4.3
4.4
26 en | RADION repeater RADION receiver SD
2014.03 | 06 | F.01U.261.834 Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
