Bosch Radion B810 - Complete the Installation; B810 System Test; External LED States

3. Select the Signal menu option and choose the desired option. Various sub-categories
display including:
– Signal strength
– Level
– Margin
4. When finished, exit the menu.
Signal strength test (for Repeaters)
Use the following procedure to test the frequency strength and range of the RADION system.
1. From the keypad, access the Wireless Menu, and select the Diagnostics menu option
2. Select the RF Repeaters menu option.
3. Select the Signal menu option and choose the desired repeater. Various sub-categories
display including:
– Signal strength
– Level
– Margin
4. When finished, exit the menu.
Notice!
For UL installations, the signal shall be checked to display “good.“
Complete the installation
Depending on the results of testing the RADION system from a system-wide approach (walk
test, signal strength and margin tests), make the appropriate modifications/adjustments to
complete the install process.
B810 system test
Overall system test
It is recommended by UL to test the entire system at least once every year, including the B810
receiver by an installer to ensure proper functionality of the RADION system.
External LED states
The receiver utilizes the External LED to show various states of the receiver. These states fall
into the following three categories:
– Normal State
– Communication Error State
– Trouble State
– Maintenance state
– Off state
Normal state:
The receiver enters a normal state when it has passed all power self-tests and has established
a communication link with the control panel . The receiver remains in this state as long as the
communication link is present, and no other issues are present that would prevent the
receiver from operating in a normal condition.
3.3.8
3.3.9
3.4
20 en | RADION receiver SD RADION receiver SD
2014.03 | 06 | F.01U.261.834 Reference Guide Bosch Security Systems, Inc.