RADION repeater
The RFRP-A is a combined receiver and transmission device that improves the overall
transmission, communication, and reliability capabilities of its assigned compatible receiver.
An LED on the front provides device status.
Features include:
– LED Display
– Cover and Wall Tamper protection
Notice!
The repeater is designed to improve the communication performance of the RADION wireless
portfolio, and not to extend the range of the wireless devices. Install the transmitters within
the suggested range for optimal performance and reliability.
Notice!
Use a supported transformer as defined in the specification table for the repeater. Do not
connect power supply to a receptacle controlled by a switch.
Installation considerations
Use the provided anchors and screws to mount the repeater in locations accessible for future
maintenance. Mount the repeater onto a wall.
Notice!
Mount the repeater in a location removed from metal. Metal objects (duct work, wire mesh
screens, boxes) reduce RF range
Wiring considerations
Notice!
Do not install long cable runs next to high-current power feeds. Keep cable lengths as short
as possible to minimize noise pickup.
Ensure that the wiring used meets the following specifications:
– Two-conductor unshielded wire.
– The minimal requirement for wire length is 1.83 m (6 ft) from the repeater
4
4.1
4.2
RADION receiver SD RADION repeater | en 25
Bosch Security Systems, Inc. Reference Guide 2014.03 | 06 | F.01U.261.834
To Next Page
Loading...
