Figure 9.3: Remove the detector cap
1 ￚ Optical base
2 ￚ Optical chamber
3 ￚ Alarm cap
5. Use compressed air or a soft-bristled brush to remove dust and dirt from the smoke
chamber base.
6. Align the optical chamber with the base and snap down into place.
7. To attach the detector cap, line the cap up with the detector, press the cap onto the
detector, and turn clockwise to snap it firmly into place.
8. Observing the proper polarity, install the batteries and the battery cover. If the batteries
are not installed properly, the detector will not fit onto the mounting base. Ensure that
the batteries are properly installed.
9. Mount the detector onto the mounting base.
10. Test the detector’s sensitivity.
42
en | RADION smoke RADION receiver SD
2014.03 | 06 | F.01U.261.834 Reference Guide Bosch Security Systems, Inc.
To Next Page
Loading...
