Bosch rexroth 4WS2EM10 5X XH Series - 7.4 Pre-Assembly Checks, Tools, and Accessories

Assembly 23/44
RE29583-XH-B/09.19, 4WS2EM10..5X/...XH..., Bosch Rexroth AG
7.4 Prior to assembly
WARNING
Explosion hazard due to wrong area of application!
A valve which is not approved for the area of application may cause an explosion!
▶ Check whether all the explosion protection marks on the name plate of the valve
comply with the information in these operating instructions.
▶ Please check if you have the right valve type by means of the type designation on
the name plate of the valve.
▶ Make sure that the zone and the temperatureclasscorrespond to the area of
application of the valve.
▶ Check the scope of delivery for completeness and possible transportdamage.
▶ Also observe the safety instructions in chapter2.6 "Product-specific safety
instructions".
▶ Transportprotection elements (e.g.cover plates, protective plugs) must be
removed prior to use in an explosive atmosphere.
7.5 Required tools
In order to assemble the valve, you need standard tools only.
7.6 Required accessories
The following accessories are recommended for the connection of the valve.
Theseaccessories can be ordered separately from BoschRexroth:
For subplates with dimensions for valves with porting pattern
accordingtoISO4401, refer to "Datasheet45100".
Table 7: Flushing plate
Material number
Flushing plate with FKM seals,
accordingtoISO4401-05-05-0-05
R900912450
Table 8: Test device
Documentation to be carried
Test device VT-SVTSY, battery-operated, can optionally be
operated with power supply unit
Datasheet29681
Subplates
Flushing plate
Test device