Bosch rexroth 4WS2EM10 5X XH Series - Disassembly and Removal; Disassembly Procedures and Safety

36/44 Disassembly and removal
Bosch Rexroth AG, 4WS2EM10..5X/...XH..., RE29583-XH-B/09.19
10.7 Spare parts
Table 9: Exchangeable filter element
Material number
Exchangeable filter element with FKM seal and FKM profile seal item (3)
in fig. 3 for filter screw M16x1
R9611001950
Table 10: Seal kit for the connection surface
Material number
Seal kit for the connection surface R9611001590
In case of questions regarding spare parts, please contact the competent
Rexrothservice:
BoschRexrothAG
Service Hydraulics
Bürgermeister-Dr.-Nebel-Str. 8
97816 Lohr am Main
Tel: +49 (0) 9352/40 50 60
service@boschrexroth.de
For the addresses of our sales and service network please refer to:
www.boschrexroth.com/adressen
11 Disassembly and removal
WARNING
Danger of damage to property and personal injuries at pressurized or energized
system parts!
For works at pressurized or energized system parts, there is a danger of injury by
escaping hydraulic fluid or electric energy.
▶ Before disassembly, ensure that the hydraulic system is depressurized, and the
electrical control is de-energized.
Explosion hazard!
Disassembly of the valve cap or the connector will lead to loss of the explosion
protection!
▶ Never disassemble valve cap or connector.
CAUTION
Falling of an incompletely disassembled valve!
An incompletely disassembled valve may fall down and cause injuries.
▶ During disassembly, secure the valve against falling.
Exchangeable filter
element
Seal kit for the
connection surface