Bosch rexroth 4WS2EM10 5X XH Series - 10.5 Exchanging the Filter Element

34/44 Maintenance and repair
Bosch Rexroth AG, 4WS2EM10..5X/...XH..., RE29583-XH-B/09.19
10.4 Repair
WARNING
Explosion hazard due to improper repair!
Improper repair will void the explosion protection!
▶ For repair works, the valve may only be disassembled to the extent described in
these operating instructions.
▶ Defective parts may only be replaced by new, interchangeable components in
original equipment quality.
▶ Never disassemble the valve cap or the connector. Disassembly of the valve cap
or the connector will lead to loss of the explosion protection.
10.5 Exchanging the filter element
The valve contains an installed, exchangeable filter element. You can also exchange
the filter element if the valve has already been installed. Replacement filter elements
with FKM seal are available as spare part, see10.7 "Spare parts".
In case of contamination, you must exchange the filter element as follows:
Fig. 3: Filter element
1 Filter screw
2 Filter element
3 Profile seal
1. Depressurize and de-energized the system.
2. Screw out the filter screw (1) (wrench size22).
3. Pull the filter element (2) out of the filter screw (1) using an M4 screw.
Cleanthefilter screw (1).
Do not clean the filter element but replace it with a new one.