Bosch Rexroth A4VG 35 Series - Page 14

14/64 Safety instructions
Bosch Rexroth AG, A4VG Series35, RE92035-01-B/2019-11-25
WARNING
Danger caused by pressurized, leaking hydraulic fluid or ejected components!
Danger to life or risk of injury! When selecting or using connecting elements
without sufficient high-pressure resistance, they may burst or lead to the leakage of
hydraulic fluid and/or to ejected components. The ports and fastening threads of
the axial piston unit are designed for the specified maximum pressure.
▶ Only ever connect connecting elements and lines that match the ports of the
axial piston unit and can resist the intended application conditions (e.g.pressure
level, flow, hydraulic fluid, temperature) with the necessary safety factors.
Escaping hydraulic fluid through leaking machine/system components!
Risk of burning and risk of injury due to escaping hydraulic fluid jet!
In case of leakage at the axial piston unit, high-pressure fluid jets may escape.
▶ Depressurize the relevant machine/system component and repair the leak.
▶ Never attempt to block or seal the leak or hydraulic fluid jet with a cloth.
CAUTION
High noise development during operation!
Danger of hearing damage, hearing loss!
The noise emission of axial piston units depends on rotational speed,
workingpressure and installation conditions, among other factors. The sound
pressure level may rise above 70 dB (A) in certain application conditions.
▶ Always wear hearing protection near a running axial piston unit.
Hot surfaces on axial piston unit!
Risk of burning!
▶ Allow the axial piston unit to cool down sufficiently before touching it.
▶ Protect yourself with heat-resistant protective clothing, e.g.gloves.
Inappropriate routing of cables and lines!
Risk of stumbling and property damage! Improper routing of cables and lines
can cause a risk of stumbling as well as damage to equipment and components,
e.g.due to lines and connectors being torn off.
▶ Always install cables and lines in a way that nobody can fall over them, that
they are not bend or twisted, do not chafe on edges and are not guided through
ducts with sharp edges without sufficient protection.