EasyManua.ls Logo

Bosch Rexroth A4VG 35 Series - Storing the axial piston unit

Bosch Rexroth A4VG 35 Series
64 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28/64 Transportand storage
Bosch Rexroth AG, A4VG Series35, RE92035-01-B/2019-11-25
6.2 Storing the axial piston unit
Storage areas should be free of corrosive materials and gases.
To prevent damage to the seals, do not operate ozone-forming devices
(e.g.mercury-vapor lamps, high-voltage equipment, electric motors, sources of
electrical sparks and/or electrical discharge) in storage areas.
Storage areas should be dry.
Recommended relative humidity ≤ 60%.
Ideal bearing temperature: +5 °C to +20 °C.
Minimum storage temperature: −50 °C.
Maximum storage temperature: +60 °C.
Keep out of direct sunlight.
Do not stack axial piston units and store them in a shock-proof manner.
Do not store the axial piston unit on the drive shaft or assembled parts,
e.g.sensors or valves.
For further storage conditions, seeTable 7.
Check the axial piston unit monthly to ensure proper storage.
The axial piston units come in corrosion protection packaging
(corrosionprotectionfilm) provided at the factory.
Table 7 lists the maximum permissible storage times for an unpackaged axial piston
unit as per datasheet90312.
Table 7: Storage time with factory corrosion protection
Storage conditions Standard corrosion protection Long-term
corrosion protection (optional)
Closed, dr
y room, uniform
temperature between +5 °C
and +20 °C. Undamaged and
closed corrosion protection
film.
Maximum 12 months Maximum 24 months
The warranty will be voided if the requirements and storage conditions are not
observed or after expiration of the max. storage time (seeTable 7).
How to proceed once the max. storage time elapses:
1. Check the entire axial piston unit for damage and corrosion prior to installation.
2. Perform a test run to check the axial piston unit for proper functioning and
leak-tightness.
3. If storage time exceeds 24 months, replace the shaft seal.
Once the max. storage time has elapsed, we recommend that you have the axial
piston unit checked by your BoschRexroth service partner.
Requirement
After delivery

Table of Contents

Related product manuals