Bosch Rexroth A4VG 35 Series - Page 29

Transportand storage 29/64
RE92035-01-B/2019-11-25, A4VG Series35, Bosch Rexroth AG
For questions regarding repair and spare parts, contact your proper BoschRexroth
service partner or the service department of the manufacturer's plant of the axial
piston unit, seechapter 10.5 "Spare parts" on page52.
An uninstalled axial piston unit must be preserved with corrosion protection for the
duration of storage.
The following instructions only refer to axial piston units operated with hydraulic
fluid on a mineral oil basis. Other hydraulic fluids require other specific
preservation measures. In such a case, consult your local contact person; you can
find their contact information at
www.boschrexroth.com/addresses
BoschRexroth recommends the following procedure:
1. Clean the axial piston unit; seechapter 10.1 "Cleaning and care" on page50.
2. Drain the axial piston unit.
3. For storage times up to 12 months: Moisten the inside of the axial piston unit
with mineral oil and fill with approx. 100 ml mineral oil.
For storage times up to 24 months: Fill the axial piston unit with VCI 329
corrosion protection (20 ml).
Fill through the drain port T
1
or T
2
; see chapter7.4 "Installing the axial piston
unit", Fig. 13 on page40.
4. Plug all ports so they are airtight.
5. Coat unpainted areas of the axial piston unit with mineral oil or suitable,
easilyremovable corrosion protection, e.g.acid-free grease.
6. Pack the axial piston unit with desiccant airproof in corrosion protection film.
7. Store the axial piston unit in a shock-proof manner; see"Requirement" on
page28 in this chapter.
After removal