Transportand storage 25/64
RE92035-01-B/2019-11-25, A4VG Series35, Bosch Rexroth AG
6 Transportand storage
▶ Always observe the necessary ambient conditions for transportand storage;
seechapter 6.2 "Storing the axial piston unit" on page28.
Information on unpacking can be found in chapter 7.1 "Unpacking" on page30.
6.1 Transporting the axial piston unit
The following transportation options are available depending on weight and duration
of transport:
• Transportby hand
• Transporting with a lifting device (eye bolt or lifting strap)
Table 6: Dimensions and weights
Size 56 71 90
Weight kg 37 48 49
Width mm Dimensions vary by equipment. The values applicable for your axial piston
unit can be found in the installation drawing (request if necessary).
Height mm
Depth mm
Weight may vary by equipment.
6.1.1 Transportby hand
Up to a specific maximum weight, axial piston units can be transported by hand for
a short distance. Observe the national regulations in your country. To prevent health
damage, we recommend renouncing any transportby hand.
CAUTION! Risk of injury due to heavy loads!
Health hazard from carrying axial piston units.
▶ Only manually transportthe axial piston unit for a short period of time.
Observethe national regulations in your country for manual transport.
▶ Always use appropriate lifting, lowering and moving techniques.
▶ Use your personal protective equipment (e.g.safety goggles, safety gloves,
suitable working clothes, safety shoes).
▶ Do not transportthe axial piston unit by sensitive assembled parts
(e.g.sensorsor valves).
▶ Carefully place the axial piston unit on the seating to prevent it from being
damaged.
6.1.2 Transportwith lifting devices
For transporting, the axial piston unit can be connected to a lifting device viaan
eye bolt in the drive shaft or in the housing. Alternatively, it can also be transported
with a lifting strap. When selecting the means of transport, consider the permissible
totalweight.
Dimensions and weights