Bosch rexroth BS 1 Series - Commissioning; Initial commissioning

22/40 Commissioning
Bosch Rexroth AG, MIT: BS 1/…, 3 842 563 815/2021-11
8 Commissioning
8.1 Initial commissioning
CAUTION
Sudden movements, falling workpiece pallets
 Injuries caused by falling objects.
 Make sure that the product has been assembled properly by qualified
personnel (seepage8) before starting it up.
NOTICE
Malfunctions due to incorrect assembly and commissioning
The product can get damaged, shortening its service life.
 Commissioning requires basic mechanical, pneumatic and electrical
knowledge.
 The product should only be commissioned by qualified personnel
(seepage8).
• Before the initial commissioning or re-commissioning of aconveyor system,
carryout arisk assessment in accordance with DINENISO12100.
• According to EUMachinery Directive2006/42/EC, you must equip the transfer
system with EMERGENCY STOP control devices.
• The surfaces of motors and gears can reach temperatures of over 65°C under
certain load and operating conditions. In these cases, you must comply with the
respective applicable accident prevention regulations (UVV) by taking appropriate
constructive measures (safety guards) or by affixing/displaying appropriate
warning signs!
• Make sure that all electrical and pneumatic connections are either used or
covered. Make sure that all bolted connections and plug-in connections are
properly seated. All relevant protective covers must be fitted.
• Only inspect and adjust continuous conveyors that are in motion or operation
when the protective equipment is in place.
• Observe DINENISO13857 when you remove or replace protective equipment
and/or bypass safety equipment.
• Test runs with open paneling should only be performed by aperson with
appropriate knowledge and experience using tip switches, and if there is no
possibility of interference from other switching devices.
• Only commission the product if all safety equipment has been installed in the
system and is ready for use.