Bosch rexroth BS 1 Series - Symbols; Designations

6/40 About this documentation
Bosch Rexroth AG, MIT: BS 1/…, 3 842 563 815/2021-11
Safety instructions are set out as follows:
SIGNAL WORD
Type and source of danger!
Consequences of non-compliance
 Measures to prevent danger
 …
• Safety sign: Points out the danger
• Signal word: Indicates the severity of the danger
• Type and source of danger: Indicates the type and source of the danger
• Consequences: Describes the consequences of non-compliance
• Prevention: States how the danger can be avoided
Table 2: Risk classes according to ANSI Z535.6-2006
Warning sign, signal word Meaning
DANGER
Indicates ahazardous situation that will result in serious
injury or death if not avoided.
WARNING
Indicates a hazardous situation that may result in serious
injury or death if not avoided.
CAUTION
Indicates ahazardous situation that may result in minor to
moderate injury if not avoided.
NOTICE
Property damage: The product or the surrounding area could
get damaged.
1.3.2 Symbols
The following symbols indicate important information that is not safety-relevant
but increases the comprehensibility of the documentation.
Table 3: Meaning of the symbols
Symbol Meaning
If this information is not observed, the product cannot be used and/or
operated as designed.

Single, independent action
1.
2.
Numbered steps:
The numbers indicate that the action steps are subsequent.
1.3.3 Designations
This document uses the following designations:
Table 4: Designations
Designation Meaning
BS1 Belt section from the Rexroth TS 1 transfer system,
for longitudinal and transverse conveying of WT 1 workpiece pallets.
BS1/T Belt section from the Rexroth TS 1 transfer system,
to drive a subsequent curve (KE 1/O).
BS1/M Belt section from the Rexroth TS 1 transfer system,
with the motor in the center of the belt section.
BS 1/S Belt section from the Rexroth TS 1 transfer system,
segmented belt section with the possibility of up to 3 additional cuts in
the longitudinal profile