Bosch rexroth BS 1 Series - Residual risks; Re-commissioning after a standstill

Commissioning 23/40
3 842 563 815/2021-11, MIT: BS 1/…, Bosch Rexroth AG
8.2 Residual risks
Table 8: Residual risks
Location Situation Hazard Action
1 Conveyor medium pinch
point
Pieces of clothing or
longhair can be pulled in
Crushing, pulling
out of hair
Do not reach into the system while it is
running. Wear protective clothing.
2 Cross connector,
driveshaft, gear:
between component and
workpiece pallet
Trapping of body parts
Shearing Do not reach into the system while it is
running.
In the work area OR at transport speeds
v > 15 m/min, a constructive solution,
e.g.asafety fence, is required.
3 Conveyor medium:
between running
conveyor and stationary
workpiece pallet
(e.g.during separation)
Trapping of body parts
Crushing Do not reach into the system while it is
running.
4 Between workpiece
pallets
Body parts can be
crushed
Crushing Do not reach into the system while it is
running.
In the work area or at transport speeds
v > 15 m/min, a constructive solution,
e.g.separation of the workpiece pallets,
isrequired.
5 End of belt section Crushing injury to body
parts caused by falling
objects
Crushing A constructive solution is required,
e.g.bymeans of astopper.
8.3 Re-commissioning after astandstill
Follow the steps outlined for the initial commissioning.
ENGLISH