2. Insert connection cable
Slide screwing (1), washer (2) and sealing (3) onto connection cable
3 x 0,75 mm
2
.
3. Connect.
Insulate cable jacket by 20 mm, the wires by 10 mm and the wires L, N, PE
in the connector insert according to the assignment. Use wire end ferrules
according to connection wires.
4. Mount connector
Mount the plug insert in the required cable output direction into the con-
nector housing, tighten the cable gland and therewith create the strain re-
lief and sealing of the connection cable. Screw the connector with housing
screw (4) with counterpart
MS2N Synchronous Motors Bosch Rexroth AG
Assembly
DOK-MOTOR*-MS2N*******-IT03-EN-P
71/95
To Next Page
Loading...
