28/54 Installation
Bosch Rexroth AG, MIT: LU 2, 3 842 358 814/2017-01
8.4 Symbols used
Table 9: Symbols used
21
Connection with T-head bolt and collar nut.
Make sure the T-bolt is in the correct position when inserting and tightening in
the slot. The notch at the end of the bolt indicates the orientation of the T-bolt.
1 = insertion position of the T-head bolt into the nut
2 = clamping position of the T-head bolt into the nut
Tightening torque: 25 Nm
SW13
M
D
= 20Nm
Hex key
SW = screw width ... mm
M
D
= necessary tightening torque … Nm
SW5
M
D
= 8Nm
Hex socket head cap screw key
SW = screw width ... mm
M
D
= necessary tightening torque … Nm
PH3
PZ2
Screwdrivers for cross-head screws
PZ … = Pozidriv screwdriver, size …
PZ … = Phillips screwdriver, size …
gleitmo
585 K
Anti Seize
Lubricate / Lubricate with specifi c grease:
• gleitmo 585 K: gleitmo 585 K, www.fuchs-lubritech.com
• Anti-Seize: Food Grade Anti-Seize/Loctite 8014, www.henkel.com
weiconlock
AN302-43
Please the following as thread locking and sealing means:
• Weiconlock AN302-43: medium strength (detachable), www.weicon.de
The marked parts are not required for the assembly described.
Dispose of the parts or use them for other purposes.
213
Graphical depiction of assembly sequence.
The numbers correspond to the sequence of assembly, in accordance with
the instructions of the accompanying text.
AB C X
Graphical depiction of components.
The letters denote the components mentioned in the accompanying text.
Detail view from a different direction, for example, on the back or bottom of
the product.
358814_2017_01_EN.indd 28 16.01.2017 13:38:19
To Next Page
Loading...