The MKE motors may only be used with the accessories specified
in the documentation. Components that are not explicitly mentioned
may be neither attached nor connected. The same is true for cables
and lines.
Operation may be carried out only in the explicitly mentioned con‐
figurations and combinations of the component and with the soft‐
ware and firmware specified in the corresponding functional
description.
Any connected drive controller must be programmed before startup in order to
ensure that the motor executes the functions specific to the particular applica‐
tion.
MKE motors may only be operated under the assembly, mounting and instal‐
lation conditions, in the normal position, and under the ambient conditions
(temperature, degree of protection, humidity, EMC, and the like) specified in
this documentation.
2.2 Inappropriate Use
Any use of MKE motors outside of the fields of application mentioned above or
under operating conditions and technical data other than those specified in this
documentation is considered to be "inappropriate use".
MKE must not be used if ...
● the ambient conditions require a higher explosion protection than is indi‐
cated on the motor's name plate.
● they are subject to operating conditions which do not comply with the am‐
bient conditions described above. For example, they must not be operated
under water, under extreme temperature fluctuations or extreme maxi‐
mum temperatures.
● the intended application is not explicitly approved by Bosch Rexroth.
Please also observe the statements made in the general notes regarding
safety.
12/131 Bosch Rexroth AG | Electric Drives
and Controls
Rexroth MKE Synchronous Motors | Project Planning Manual
Important Instructions on Use
To Next Page
Loading...
