Bosch Rexroth MM7.10 - Installation; Unpacking and Installation Conditions; Mounting the Inertial Sensor

16/24 BODAS inertial sensor MM7.10 | Installation
BoschRexrothAG, RE 95178-01-B/2022-06-22
7 Installation
Prior to installation, the following documents should be to hand:
• Data sheet of the product (contains the permissible technical data,
main dimensions and circuit diagrams of standard versions)
7.1 Unpacking
NOTICE! Danger due to electrostatic discharge!
When unpacking the sensor, there is adanger of damage to the electronic
components of the sensor due to electrostatic discharge.
▶ When unpacking, protect the sensor against electrostatic discharge;
information on the protection of the sensor against electrostatic discharge(ESD)
can be found in the respective data sheet 95178.
▶ Remove the packaging from the inertial sensor.
▶ Check the sensor for transport damage and completeness, see chapter4
"Scope of delivery" on page12.
▶ Dispose of the packaging in accordance with the regulations in your country.
7.2 Installation conditions
The installation position and location of the inertial sensor essentially determine
the procedures for installation and commissioning.
▶ Do not install the sensor close to parts that generate considerable heat
(e.g.exhaust system).
▶ Lines are to be routed with sufficient distance from hot or moving vehicle parts.
▶ A sufficient distance to radio systems must be maintained.
▶ Before electric welding and painting operations, the sensor must be diskonnected
from the power supply and the sensor connector must be removed.
▶ Cables/wires must be sealed individually to prevent water from entering
the sensor.
7.3 Mounting the inertial sensor
7.3.1 Preparation
1. Use the material number on the sticker of the packaging unit or directly
on the sensor to check whether the correct inertial sensor is available,
see chapter 5.2 "Product identification" on page14.
2. Compare the material number with the details in the order confirmation.
If the material number of the inertial sensor does not match the one in the
order confirmation, contact your local contact person for clarification.
You can find their contact information at
https://addresses.boschrexroth.com