Bosch Rexroth MM7.10 - Information Representation

RE 95178-01-B/2022-06-22, BoschRexrothAG
About this documentation | BODAS inertial sensor MM7.10 5/24
1.3.1 Safety instructions
This documentation contains safety instructions in chapter2.6
"Product-specific safety instructions" on page10 and in chapter3
"General instructions on property damage and product damage" on page11,
as well as before asequence of actions or an instruction for action involving arisk
of personal injury and property damage. Always follow the measures for danger
prevention associated with the use of this product.
Safety instructions are set out as follows:
SIGNAL WORD
Type and source of danger!
Consequences of non-compliance
▶ Danger prevention measures
• Warning sign: draws attention to the danger
• Signal word: identifies the degree of the danger
• Type and source of danger: indicates the type and source of the danger
• Consequences: describes the consequences of non-compliance
• Precautions: states how the danger can be avoided
Table 2: Hazard classes as defined in ANSI Z535.6
Warning sign, signal word Meaning
DANGER
Identifies adangerous situation that will result in death or
serious injury if it is not avoided.
WARNING
Identifies adangerous situation that may result in death or
serious injury if it is not avoided.
CAUTION
Identifies adangerous situation that may result in minor to
moderate injury if it is not avoided.
NOTICE
Property damage: The product or surrounding area may be
damaged.
1.3.2 Symbols
The following symbols indicate notices that are not safety-relevant but increase
understanding of the documentation.
Table 3: Meaning of symbols
Symbol Meaning
If this information is disregarded, the product cannot be used and/or
operated to its full extent.
▶
Single, independent action
1.
2.
3.
Numbered instruction:
The numbers indicate that the actions must be completed in order.