Bosch Rexroth MM7.10 - Safety Instructions; Intended and Improper Use

RE 95178-01-B/2022-06-22, BoschRexrothAG
Safety instructions | BODAS inertial sensor MM7.10 7/24
2 Safety instructions
2.1 About this chapter
The product has been manufactured in accordance with generally accepted
engineering standards. There is still, however, adanger of personal injury or
property damage if this chapter and the safety instructions in this documentation
are not observed.
▶ Read this documentation completely and thoroughly before working with
the product.
▶ Keep this documentation in alocation where it is accessible to all users at
all times.
▶ Always include the required documentation when passing the product on to
third parties.
2.2 Intended use
The sensor is intended as acomponent for application in mobile working machines.
The sensor may only be commissioned after it has been installed in the
machine/system for which it is intended and the safety of the entire system has
been established in accordance with the Machinery Directive.
The purpose of the MM7.10 inertial sensor is to measure the physical effects of
the yaw rate, rate of roll, and of transverse, longitudinal and vertical acceleration.
▶ Generally, the sensor must be operated within the operating ranges specified
and approved in the datasheet 95178, particularly with regard to voltage,
temperature, vibration, shock and other described environmental influences.
▶ Its use outside of these specified and approved boundary conditions may result
in danger to life and/or cause damage to components which could result in
sequential damage to the mobile working machine.
▶ Serious personal injury and/or damage to property may occur in case of
non-compliance with the appropriate regulations.
▶ Observe the corresponding IP protection class.
The product is intended only for professional use and not for private use.
Intended use includes having fully read and understood this documentation,
especially chapter 2 "Safety instructions" on page 7.
2.3 Improper use
Any use other than that described as intended use is considered improper.
BoschRexrothAG is not liable for damage resulting from improper use.
The user is solely responsible for any risks arising from improper use.
The following foreseeable forms of faulty usage are also considered improper
(this list is not exhaustive):
• Use outside the operating parameters approved in the datasheet
(unless customer-specific approval has been granted)
• Application of the sensor in explosive environments