Bosch Rexroth MM7.10 - Inspection, Repair, and Replacement; Disposal and Conversion

20/24 BODAS inertial sensor MM7.10 | Removal and replacement
BoschRexrothAG, RE 95178-01-B/2022-06-22
10.2 Inspection and maintenance
No special activities are necessary.
10.3 Repair
The sensor cannot be repaired.
When replacing the sensor, make sure that no contamination can penetrate the
hydraulic system and that the sealing surface of the sensor is not damaged.
▶ Only use original spare sensor from Rexroth, otherwise the functional reliability
cannot be guaranteed, and the warranty will be voided.
▶ Spare parts can be found online at www.boschrexroth.com/eshop
Address all questions regarding repair to your responsible BoschRexroth service.
11 Removal and replacement
▶ Only disassemble the inertial sensor when de-energized.
12 Disposal
Careless disposal of the inertial sensor can lead to environmental pollution.
▶ Dispose of the inertial sensor and the packaging material in accordance with
the national regulations in your country.
13 Extension and conversion
You must not convert the inertial sensor.
The warranty from BoschRexroth only applies to the configuration as delivered.
Entitlement to warranty cover will be rendered void in case of conversion,
upgrade or asoftware modification.