Bosch Rexroth MM7.10 - Commissioning; Commissioning Procedure; Operation; Product Operation

RE 95178-01-B/2022-06-22, BoschRexrothAG
Commissioning | BODAS inertial sensor MM7.10 19/24
8 Commissioning
During all work for commissioning the inertial sensor, observe the general
safety instructions and intended use detailed in chapter 2 "Safety instructions"
from page7 on.
▶ When commissioning the sensor, the machine may pose unforeseen hazards.
Before commissioning the system, you must therefore ensure that the vehicle
and the hydraulic system are in asafe condition.
▶ Commission the machine and check the correct functioning of the sensor.
9 Operation
This product is acomponent which requires no settings or changes during operation.
For this reason, this chapterof the manual does not contain any information on
adjustment options. Use the product only within the performance range specified in
the technical data.
10 Maintenance and repair
10.1 Cleaning and care
NOTICE
Damage to seals and electronics/electrics due to mechanical effects!
A water jet may damage the seals and electronics/electrics of the sensor!
▶ When cleaning with awater jet, the IP protection class must be observed;
depending on this, the water jet may not be directed at the sensor.
For cleaning and care of the sensor, observe the following:
▶ Check whether all the seals and fittings on the plug-in connections are
securely seated to ensure that no moisture can penetrate into the sensor and
the installation space during cleaning.
▶ Use only water and, if necessary, amild cleaning agent to clean the sensor.
Never use solvents or aggressive cleaning agents.