Bosch Rexroth MM7.10 - Page 9

RE 95178-01-B/2022-06-22, BoschRexrothAG
Safety instructions | BODAS inertial sensor MM7.10 9/24
• Only commission the product if it has been determined that the end product
(e.g.machinery/system) in which the Rexroth products are installed corresponds
to the country-specific provisions, safety regulations and standards for the
application.
• Use tools appropriate for the work being performed and wear appropriate
protective clothing to prevent punctures and cuts (e.g.when removing protective
covers, disassembly).
• The sensor contains electronic components and may thus be damaged by
electrostatic discharge. Observe the handling instructions for electrostatically
endangered components, see data sheet95178.
• The proposed circuits do not imply any technical liability for the system or the
machine on the part of BoschRexroth.
• Opening the sensor or carrying out modifications to or repairs on the sensor
is prohibited. Modifications to or repairs on the wiring can lead to dangerous
malfunctions.
• The sensor may only be assembled/disassembled in ade-energized condition.
• Make sure that nobody is in the machine’s danger zone.
• Do not use defective components or components which are not in aproper
working order. If the sensor fails or demonstrates afaulty operation, it must
be replaced.
• Protect the sensor during transport, processing and/or assembly against the
ingress of humidity, paints or other substances into the connector chamber.
• Despite the greatest care being taken when compiling this document,
it is impossible to consider all feasible applications. If information on your
specific application is missing, please contact BoschRexroth.
• If other or more specifications apply to the marketing of the product or if there
is marketing outside the specified target markets, you must demand compliance
with the target market-specific regulations from BoschRexroth or ensure their
compliance yourself.