6/78 About this documentation
Bosch Rexroth AG, Control block SB24/34, RE 66170-B/2019-05-15
Table 1: Required and supplementary documentation
Title Document number Document type
Hydraulic fluids based on mineral oils and related hydrocarbons
Describes the requirements for hydraulic fluids on mineral oil basis and
related hydrocarbons for operation with Rexroth hydraulic components,
and provides support for selection of suitable hydraulic fluids for the
hydraulic system.
90220 Data sheet
Environmentally acceptable hydraulic fluids
Describes the requirements for environmentally acceptable hydraulic
fluids on mineral oil basis and related hydrocarbons for operation with
Rexrothhydraulic components, and provides support for selection of
suitable hydraulic fluids for the hydraulic system.
90221 Data sheet
For further documentation on installation and repair, refer toTable 36 on
page69 or visit Rexroth on
www.boschrexroth.com/mobile-hydraulics-catalog.
1.3 Representation of information
Standardized safety instructions, symbols, terms and abbreviations are used
throughout this documentation to ensure safe and proper use of the product.
Forclarification, they are explained in the sections below.
1.3.1 Safety instructions
This documentation includes safety instructions in chapters2.6 "Product-specific
safety instructions" on page11 and3 "General instructions on property damage
and product damage" on page14, as well as prior to sequences of actions or
instructions with risk of injury or property damage. Always follow the measures
fordanger prevention associated with the use of this product.
Safety instructions are set out as follows:
SIGNAL WORD
Type and source of danger
Consequences of noncompliance
▶ Measures to prevent danger
• Warning sign: draws attention to the danger
• Signal word: identifies the degree of the danger
• Type and source of danger: indicates the type and source of the danger
• Consequences: describes what occurs if safety instructions are disregarded
• Precautions: states how the danger can be avoided