Bosch Rexroth SB24/34 - 12 Disposal; Spring-loaded Components and Disposal Procedures

Disposal 71/78
RE 66170-B/2019-05-15, Control block SB24/34, Bosch Rexroth AG
12 Disposal
CAUTION
Spring-loaded components!
Risk of injury due to ejected components during disassembly of the valve into its
individual parts!
▶ Loosen screwed-in and spring-loaded components slowly and keep secured
untilthe compression spring is relieved.
Careless disposal of the control block/control block segment, the hydraulic fluid
andthe packaging material may lead to environmental pollution!
For disposal of the control block/control block segment, observe the following
points:
1. Drain the control block/control block segment completely.
2. Dispose of the control block/control block segment and the packaging in
accordance with the national regulations of your country.
3. Dispose of the hydraulic fluid in accordance with the regulations of your country.
4. Disassemble the control block/control block segment into its individual parts and
recycle them.
5. For example, separatethe parts into:
– Metals
– Electronic waste
– Plastic