12/32 Bosch Rexroth AG | Hydraulics Installation and Operation | RE 30126-B/09.13
2 Installing the VRPD
2.4 Card Installation
Remove the card from its packaging only at a protected work place.
Do not touch any electrical components when placing the controller card in its proper
card holder as shown in Fig. 2.
Correctly installing the VRPD controller card:
¾ Remove power from the rack when installing the card.
¾ Hold the card by the front panel and remove it from the packaging.
¾ Slide the card into the guide rails of the rack without using excessive force, as
shown in Fig. 2 Installing the controller card.
¾ Snap the edge connector in place by gently pressing on the front panel.
HACD_HW_EN_2-2
mounting
screws
male connector
card
Fa
ceplate
guide rails
Fig. 2 Installing the controller card
¾ Tighten the two mounting screws on the front panel.
9 The card is now installed correctly.
To Next Page
Loading...
