RE 30126-B/09.13 | Installation and Operation Hydraulics | Bosch Rexroth AG 21/32
Startup of the VRPD Controller Card 3
3.2 Installing BODAC software
BODAC software (ordering code SYS-HACD-BODAC-01 ordering number
R900777335) can download via Internet (
www.boschrexroth.com/hacd
). This software
is used for initial startup and as a convenient configuration and monitoring tool for the
controller card. BODAC can be used to configure the settings and parameters for
optimal operation of the VRPD controller card. The connected VRPD card configures
the function, menus and program windows in BODAC. This makes using the software
easy.
Installation Requirements
100% IBM compatible PC with the following minimum requirements:
200 MHz Pentium processor (or equivalent)
32 MB working memory (RAM)
VGA graphics card, minimum resolution: 800x600 pixels
Hard drive with minimum 2 MB available space
CD-ROM drive
Mouse
Available serial port
Operating system: Windows 2000 / XP.
If the hardware/software requirements are met, you can install BODAC as described
in the next section.
BODAC Setup
To start the installation of BODAC, execute the “Setup.exe“ file.
Installing BODAC software:
¾ Insert the CD-ROM and locate the file “Setup.exe“.
¾ Double-click on “Setup.exe“.
9 The setup program will load and display a start screen.
¾ To run Setup, follow the instructions on the screen.
9 BODAC software will then be installed.
Hardware
Software
To Next Page
Loading...
