24/32 Bosch Rexroth AG | Hydraulics Installation and Operation | RE 30126-B/09.13
4 VRPD Operation
The serial port on the front panel is configured as a standard RS-232 port using a 9-
pin D-Sub female connector. A standard 9 pin serial data cable is used to connect the
serial port to a PC.
4.2 Diagnostics Test Jacks
The diagnostic test jacks on the front panel of the card can be used to connect exter-
nal test instruments. Two analog voltage signals are available to perform measure-
ments.
Serial port
To Next Page
Loading...
