Bosch Security System - Page 30

Part II: System Commands
Security System User's Guide 4998122475C
Press the COMMAND key and then the one or two digits shown in the table below to perform the function. When you
use a command to perform a function, the displays in the function list below do not appear at your command center.
COMMAND Function
Master Arm
Perimeter Instant
Perimeter Delay
Silence Trouble Sounder &
Clear Trouble Display
+
View Memory
+
Walk Test
+
Reset Sensors
Watch Mode
Special Alert
COMMAND Function
Perimeter Partial
Special Alert
Bypass a Point
+
Unbypass a Point