Appendix
Standard Displays
4998122475C Security System User's Guide
Standard Displays
Your command center uses standard and custom displays to show the status of the security system. Many standard
displays are described below. Your system may not use all of them. Descriptions of your custom text follow.
*System Command*
Displays when you press
the COMMAND key. The
system is waiting for you
to enter a one or two digit
number to complete the
command.
Entry Delay display
When the system is turned on, entering through a delay
door starts entry delay time. The command center emits
a tweedle tone and displays the following:
Enter passcode and press
the ENTER key to
disarm
followed by Area # Name
Text is in entry delay.
You must turn off the system before entry delay time
expires to avoid creating an alarm event.
Exit Delay display
Arming your system starts exit delay time. The
command center emits a repeating beep tone and
displays the following
Exit now! # seconds
remaining (# = the
number of seconds left in
exit delay).
To Next Page
Loading...
Need help?
General
