Bosch Security System - Walk Test (Command + 4 + 4)

Part II: System Commands
WALK TEST ? (COMMAND + 4 + 4)
4998122475C Security System User's Guide
WALK TEST ? (COMMAND + 4 + 4)
Walk Test
Description
Use this function to test command centers, detection
devices, and sounders (both interior and exterior) to be
certain they function properly. You can review untested
points at your command center to help pin-point any
problems.
You cannot arm your system while in the walk test mode,
and no alarm reports are sent to your security company
unless a 24-hour point is activated (such as fire or panic).
Upon initiation, the walk test will test the burglary bell
pattern on the bell output and ring the command center
burglary bell for 2 seconds. The AC will be disabled for 4
minutes in order to test the system’s battery power.
If the battery cannot maintain the system for the 4-minute
period, the command center will appear to go dead. If this
happens, contact your security company. At the end of the
4-minute period, AC is returned to the system and the
panel restores. To test individual detection devices, simply
activate sensors and open protected doors and windows
one-at-a-time. As each detection device is faulted, the
Command Center emits a brief tone and the display
indicates for 60 seconds that the point has been tested.
This verifies that each detection device is working
properly.