Bosch Security System - View Memory? (Command + 4 + 0)

Part II: System Commands
VIEW MEMORY ? (COMMAND + 4 + 0)
4998122475C Security System User's Guide
VIEW MEMORY ? (COMMAND + 4 + 0)
View Event Memory
Description
Your system stores events that occurred since the last
time display was cleared. Use COMMAND 40 to view
Event Memory.
Event Memory allows you or a service technician to
review events after they are cleared from the command
center’s display. *Alarm Silenced* will continue to
scroll to remind you that events are stored in Event
Memory.
Each time you turn the system on, the Event Memory is
erased and the *Alarm Silenced* message is cleared.
Using View Memory:
1.
Ensure your
command center
shows idle
disarmed text.
2.
Press the COMMAND key.
3.
The display
shows *System
Command*.
4.
Press the 4 key,
followed by the 0 key.
+