Bosch SHP65CC5UC - Page 47

Troubleshooting en-us
47
Issue Cause and troubleshooting
Wipeable or water-
soluble coatings inside
the appliance or on the
door.
There is detergent residue. These coatings cannot
generally be removed with chemicals.
▶ Change your Detergent.
▶ Scrub the appliance by hand.
White coating is deposited inside the appliance.
1. Adjust the water softening system correctly.
→ "Setting the water softening system", Page22
In most cases you will need to increase the setting.
2. If necessary, change your detergent.
Special salt dispenser is not screwed tight.
▶ Screw the special salt dispenser tight.
There are stubborn
white coatings on the
dishware, inside the
appliance or on the
door.
There is detergent residue. These coatings cannot
generally be removed with chemicals.
▶ Change your Detergent.
▶ Scrub the appliance by hand.
Hardness range is set incorrectly or the water hardness
is too high.
▶ Set the Water softening system to the water hardness
or add special salt.
3in1/organic/eco detergent is not effective enough.
▶ Set the Water softening system to the water hardness
and use separate detergents (name brand, special
salt, rinse aid).
Too little detergent is being used.
▶ Increase the amount of detergent used or change
Detergent .
Selected wash cycle is too light.
▶ Select a more intensive wash program.
Tea residue or lipstick
marks on dishware.
Dishwashing temperature is too low.
▶ Select a program with a higher dishwashing
temperature.
Too little detergent is being used or is unsuitable.
▶ Use a suitable Detergent and follow the
manufacturer's instructions for the amount to be
used.
Dishware has been precleaned too intensively. Then the
sensors choose a lighter cycle. Stubborn remnants
cannot be entirely removed.