Bosch SHP65CC5UC - Page 49

Troubleshooting en-us
49
Issue Cause and troubleshooting
There are removable
streaks on glasses,
glassware with a
metallic appearance
and silverware.
Amount of rinse aid to be dispensed is set too high.
▶ Set the rinse aid system to a lower setting.
→ "Setting the amount of rinse aid", Page25
No rinse aid has been added.
▶ Add rinse aid.
→ "Adding rinse aid", Page24
There is detergent residue in the final rinse. Lid of
detergent dispenser is blocked by dishware and will not
open fully.
1. Arrange dishware in the upper rack so the tab
collecting tray is not obstructed by dishware.
→ "Loading dishware", Page29
Items of dishware are blocking the dispenser lid.
2. Do not place dishware or fragrance dispensers in the
tab collecting tray.
Dishware has been precleaned too intensively. Then the
sensors choose a lighter cycle. Stubborn remnants
cannot be entirely removed.
▶ Only remove large remnants of food and do not pre-
rinse dishware.
Irreversible clouding of
glassware.
Glasses are not dishwasher-proof, only suitable for
dishwashers.
▶ Use dishwasher-proof glasses.
Glasses are usually only suitable for cleaning in a
dishwasher, i.e. long-term wear or long-term changes
must be expected.
▶ Avoid a lengthy steam phase (standing time after
wash cycle ends).
▶ Use a program with a lower temperature.
▶ Set the softening system to the water hardness.
→ "Setting the water softening system", Page22
▶ Use detergent with a glass protection component.
Detergent residue is
present in the
detergent dispenser or
the tab collecting tray.
Spray arms were blocked by dishware so detergent was
not rinsed out.
▶ Check that the spray arms are not blocked and can
rotate freely.
Detergent dispenser was damp when detergent was
added.