Bosch Smart Home controller II User Manual

Smart Home Controller II English | 8
8-750-002-895 | V001 | 01/2024 Bosch Smart Home
↑Content
The status LEDs (2, 3, 4) show the status of the controller using ashing
codes.
Power
LED
Status Recommended action
Flashes
yellow
Device starting up
Wait until the device has fully
started up.
Lights green The device has started up None
Flashes red Start-up failed
Disconnect the Smart Home controller from
the power and reconnect it. If the LED ashes
red again, then check the internet connection;
connect the controller to another network if
possible.
Network
LED
Status Recommended action
Flashes
yellow
Searching for a network
connection
None
Lights green
Network connection
established
None
Flashes red Network connection failed Check your network settings.
Cloud
LED
Status Recommended action
Flashes
yellow
Update is being downloaded
from the Bosch Cloud or data
is being exchanged via the
tunnel connection.
None
Lights green
Remote access via the
Bosch Cloud is activated and
established.
If you do not want to access your Smart Home
system while out and about, then you can
deactivate remote access in the Smart Home
app.
Flashes red
Bosch Cloud connection failed
and remote access to your
Bosch Smart Home system is
not currently possible.
Disconnect the Smart Home controller from
the power and reconnect it. If the LED ashes
red again, then check the internet connection.
432

Bosch Smart Home controller II Specifications

General

Power Supply	5V DC, 1A
Storage Temperature	-20°C to 60°C
Protection Class	IP20
Wireless Protocols	Zigbee 3.0
Operating Temperature	0°C to 40°C
Compatibility	Bosch Smart Home System
Operating Humidity	20% to 80% (non-condensing)
Relative Humidity	5% to 95% non-condensing